CONTENTS OF THE BOOKLET
I. USER’S MANUAL ...................................................... 3
II. WATER RESISTANCE ............................................... 6
III. WATCH WITH 2416 MOVEMENT ........................ 9
IV. WATCH WITH 2432 AND 2435 MOVEMENT ... 13
V. WARRANTY ............................................................. 18
|
I. USER’S MANUAL FOR ALL TYPES OF MECHANICAL WATCHES
Your watch is repairable, but the watch back cover can be
opened and any repair works should be carried out
only by specialists-watchmakers in watch-shops.
The watch is a complex technical device, which requires
careful handling.
It will work trouble-free and keep high accuracy if
you do the following:
- wear the watch with automatic winding on your wrist
not less than 10 hours a day;
- protect the watch from falling and sharp shocks;
avoid exposing the watch to strong magnetic fields
and chemical agents;
|
- clean, lubricate and adjust as well as to check water impermeability of “water-resistant” watch not less than once in two years after warranty is expired;
It is not recommended:
- to open the case or remove its back cover; by that you protect your watch from un qualified service and ingress of dirt and dust into the watch movement;
- to expose the watch to temperature extremes as that causes weeping of the crystal.
Resistance to influence of magnetic fields with intensity less than 4800 A/M. Average watch life is 10 years in case of correct use.
|
Watches with automatic winding up
Mechanical watches with automatic winding up of the mainspring do not require manual winding.
Spontaneous movements of your hand make the rotor (oscillating weight) turn and thus winding the mainspring of the watch. Daily routine is enough for automatic winding up of the watch and it will go for a long time even if it is taken off the hand for a night. However, if the watch is not put on for 31 hours it will stop. In order to make the watch go again, rotate the watch crown clockwise about 25-30 turns, then set the time and the date. You can see an auto rotating oscillating weight in automatic watches with glass back cover.
|
II. WATER RESISTANCE
Level of water resistance and possibilities to use the watch correspond with the marking on the watch back cover.
-«Water resistant» or «Водонепроницаемые» – you can wash yourself, when there is no splashing of water under pressure;
- «Water resistant 3 ATM» or «Водонепроницаемые 3 ATM» – you can wear the watch in rain and wash yourself under a faucet, when water is splashed up under small pressure;
- «Water resistant 5 ATM» or «Водонепроницаемые 5 ATM» – you can water your garden and wash your car with water coming out of a hose;
|
- «Water resistant 10 ATM» or «Водонепроницаемые 10 ATM» – you can swim and dive (but not from a tower) and to swim under water without a scuba. Water resistant 5 and more atmospheres watches are as a rule equipped with screwed watch crowns. To set hands, wind up the watch, change the calendar setting or set a signal you should unscrew the screwed crown. (See picture 1)
Do not manipulate the watch crown underwater.
Recommendation: please test water resistance of your watch once every two years atyour service – center.
|
 |
III. WATCH WITH 2416 MOVEMENT
TECHNICAL SPECIFICATIONS
(See Picture 2)
Caliber of the movement – 24 mm
Movement height – 5.7 mm
Sweep-type second hand
Shock-resistance device of a balance staff
Calendar – single, instantaneous function
Correction of date-of-the-month by setting with handrotation.
31 Ruby jewels
Balance period – 0,33 s
Mean daily rate from –10 to + 30 s/day
Autonomy at least 31 hours
|
 |
USER’S MANUAL
1. The watch is wound by rotation of the watch crown.Winding should be stopped when it meets resistance.
2. The hands are set the following way: a watch crown should be pulled out from the case to the fixed position and then rotated clockwise to set the right time. Then the watch crown should be returned to the initial position.
3. Date-of-the month changes automatically once a day.
4. To change the date you should fix the watch crown in the position “setting hands” and then move hands clockwise to the position “12 o’clock” counter-clockwise to “8 o’clock” by rotating the watch crown.
|
If it is necessary to change the date-of-the month for more than one day, the hands should be moved counter-clockwise to “8 o’clock” and then again clockwise to the position “12 o’clock”. The date-of-the month shifts one day per each cycle of moving hands within the range “12-8-12”. When the date-of-the month is set, the hands should be set to time reckoning clockwise. When hands are set to time reckoning after 12 a.m., they should be moved one full wind clockwise and then set to a desired position.
|
IV. WATCH WITH 2432 and 2435 MOVEMENT
TECHNICAL SPECIFICATIONS
(See Pictures 3-5)
Caliber of the movement – 24 mm
Movement height – 5.7 mm
Sweep-type second hand
Shock-resistance device of a balance staff
Calendar – single, instantaneous function
Correction of date-of-the-month by setting with handrotation.
Day&night disc; - 31 Ruby jewels; - Balance period – 0,33 s
Mean daily rate from –20 to + 40 s/day
Autonomy at least 31 hours
|
 |
 |
 |
USER’S MANUAL
1. The watch is wound by rotation of the watch crown.Winding should be stopped when it meets resistance.
2. To change the date - see IV.4 paragraph
3. The hands are set the following way: a watch crown should be pulled out to the fixed position and then rotated clockwise to set the right time. Then the watch crown should be returned to the initial position.
4. The position of day and night indicator or 24-hours counter is set together with setting of hands. Please pay your attention that black color of day&night indicator (which could be used in many models) corresponds to the night time.
|
V. WARRANTY
The warranty period is valid for 12 months from the date of the purchase.
The customer shall not have any claim under this warranty if: the watch does not have the passport; the watch has been repaired by unauthorized service; the watch is not used in accordance with the instructions supplied in the present User Manual.
The Warranty does not cover the watch-case, a band, bracelet and the packing. If hidden faults are detected in during the warranty period, the watch can be repaired at the warranty watch service shop at the following address:
Koliz Vostok Co. Ltd. Naugarduko str. 41, 03227 Vilnius-6,
Lithuania or at the address marked by your local distributor.
|
The right for warranty service is provided by the guarantee certificate attached to the given passport-booklet of your watch.
The claims on watch replacement or repayment are satisfied upon submission of the certificate from the guarantee service.
|
